Knit-along

Week Two: Flex Tee KAL

Week Two of our Knit-Along is in the bag - but if you haven't started yet, don't worry - more people have been joining us and are just starting out.

This week we reviewed the construction of the garment and talked about stitch markers! One of the many reasons I was excited to host a knit-along for the Flex Tee was the interesting construction, but fairly simple knitting.  Once you have the front and back panels knit, you will need to cast on more stitches for the sides, put in your stitch markers and start knitting in the round!

Here is a little diagram to help you figure out what you are doing. If you are not sitting with the pattern, this may be completely confusing, but it will help you visualize what you are doing:

(Orange arrows represent the direction of knitting.) The instructions have you knit across the back, and place a marker (#1). Then cast on stitches for 1/2 of the left side, place a marker (#2), cast on the other 1/2 of stitches for the left side. Place a marker (#3) as you join the front, and knit across your held stitches, placing a marker (#4) before you cast on 1/2 of your right side edge.  Place marker (#5) and cast on the remainder of your right side stitches, and finally, place a very noticeable marker (#6) for your beginning of round. WHEW!

I would recommend that markers 1,3,4, & 6 be related in color or kind, and that markers 2 & 5 be a totally different color. This will help you tremendously as you navigate the decreases and occasional increases.

Hope you are having fun!

Week One: Flex Tee

Today was our first KAL meet-up, and we had a great turn out, even with down pouring rain and severe weather alerts!

We measured, knit, and reknit swatches - almost all of us had to go up a needle size (or two!) to get gauge. I knit my swatch in the round using Magic Loop. Flex has two smaller panels knit flat, and then the rest of the garment is knit in the round. Since the majority of the garment is knit in the round - so is my swatch!

I got to demonstrate my favorite join for ribbon/ chainette/ hollow core yarns (the ones that look like i-cord, flat tape, or tubes), and you can learn the technique here. This technique is great for joining yarns without leaving ends to weave in.  There are a few things to be aware of with this technique, however.

1. The yarn will be double-thick at the join, and this can be visible. So make sure that your join occurs at the sides of your garment, and not directly over your stomach, or worse, your chest!

2. Normally this join requires you use a Chenille needle - basically a sharp-tipped darning needle. With more tightly woven ribbon yarns the sharp needle is essential. Since Kestrel is a looser chainette yarn, a blunt tip needle will actually be more helpful - but use a straight one, not one with a bent tip.

I am so excited to see everyone's progress next week!

 

Flex Tee pattern by Heidi Kirrmaier for Quince and Co. Knit by Lynn Schense in Quince and Co Kestrel, color Aegean.

Flex Tee pattern by Heidi Kirrmaier for Quince and Co. Knit by Lynn Schense in Quince and Co Kestrel, color Aegean.

Chenille_needles.jpg